Monster Mods Forum
Please log in to make post and check your personal messages. Or register if you are a new user.


Xbox 360 Modding Community
 
HomeCalendarGalleryFAQMemberlistUsergroupsRegisterLog in

Share | 
 

 Partial Controller Sync?????

View previous topic View next topic Go down 
AuthorMessage
Deadeye
Modder
avatar

Number of posts : 56
Location : MN
Reputation : 1
Points : 83
Registration date : 2009-04-12

PostSubject: Partial Controller Sync?????   Tue May 25, 2010 1:29 pm

OK, I know I've been off the forums for awhile, but now I'm back from school for the summer.
My latest project is putting my 360 into an original xbox case. What I'm doing is frosting the xbox jewel and putting the rol under that and i have it hooked up so you push the jewel to turn it on and it lights up all cool and whatnot. my issue is my controller only partially syncs to the system, I had to run a ribbon cable to put the rol where it is and It all works and the controller turns the system on but nothing more. If i press sync on both the system and the controller it will flash all 4 lights on both to recognize the sync, but no player 1 light lights up.


Are the pinouts different for the mobo versus the rf board?

Thanks!
Back to top Go down
View user profile
muns88
New MM user


Number of posts : 23
Age : 29
Location : Mankato, MN, USA
Reputation : 0
Points : 33
Registration date : 2009-04-13

PostSubject: Re: Partial Controller Sync?????   Wed May 26, 2010 9:13 am

I would guess that whats happening is this:

The RF board is what the console uses to communicate with the controller, and if you relocated it it might not be getting a solid connection between the RF board & the motherboard, therefore hindering the connection between the controller & the motherboard. SO... double check all your solder connections & make sure they are solid. That would be my first guess.
Back to top Go down
View user profile http://www.kato360.com/
Deadeye
Modder
avatar

Number of posts : 56
Location : MN
Reputation : 1
Points : 83
Registration date : 2009-04-12

PostSubject: Re: Partial Controller Sync?????   Wed May 26, 2010 3:46 pm

yeahh. i posted this up on llamma too btw. I dont know? Do I need to run a ground wire too? I just wish there was a pinout diagram somewhere online for it...
I've resoldered both ends twice. looking with a crappy magnifying glass i dont see any bridges but tomorrow (today) I'll try again i guess
Back to top Go down
View user profile
Sponsored content




PostSubject: Re: Partial Controller Sync?????   

Back to top Go down
 
Partial Controller Sync?????
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Pro Controller
» Controller - Dead zone setup for circuit racing
» modded controller
» Using a controller to play Crusade
» MLG Controller

Permissions in this forum:You cannot reply to topics in this forum
Monster Mods Forum :: Xbox 360 Forums :: Xbox 360 Modding Discusion-
Jump to: